LTCast LTCast
/ Version compare
Manual › Version compare

Version compare

A new master arrives the morning of the show, two bars longer in the intro. Version compare lines the old and the new file up by sound, works out what was added or removed, and moves every cue in that song onto the new version in one undoable step. Cues it is not sure about are moved to its best guess and listed, so you can check them and nudge them before you apply.

One song

  1. Expand the song card (click its chevron) and click the ⇄ button (Replace audio, a Pro feature; the trial includes it), then pick the new file. It is not in the right-click menu.
  2. LTCast analyses both files and opens Version compare, with the current version in one lane and the new one in the other. Choose… next to the new file lets you pick a different one.
  3. Check what it found: the Start offset between the two files, the sections marked added or removed, and the count of cues it is about to remap, split into solid and to confirm.
  4. Look through the To confirm list — cues that sit in a repeated section, where a chorus can look like any other chorus. LTCast has already placed each one at its best guess. Each row has a play button to hear the new spot, − and + buttons that nudge it by 0.1 s, and a Mark reviewed button. Marking a row only turns it green as your own reminder: Apply & swap works whether you mark the rows or not.
  5. Click Apply & swap. Markers, MIDI cues, regions, the song map, and the lyric end all move together, and Ctrl+Z puts it all back.

Checking the fit by ear

Audition plays the two versions against each other: click a lane to play from that point, press space to stop, and set a per-source Volume so you can hear the difference rather than guess it. Only channel 0 is played, so a file with an embedded LTC or control tone stays silent, and the audition never touches the show's own audio engine.

When it is not the same song

If the two files do not sound like the same song, LTCast says so and turns auto-remap off — it will not drag your cues onto a different track. Swap file only (keep cues) replaces the audio and leaves every cue at its time (markers that would fall past the end of a shorter file are moved to just before it). Apply & swap is greyed out in this state.

Overall shift

Overall shift is a slider from −2 s to +2 s that moves every remapped cue by the same amount, on top of what the analysis worked out. Use it when the remap is right but everything sits a touch early or late. It does not replace the remap, and it only takes effect with Apply & swap.

A whole set at once

Click ⋯ in the setlist header and choose Version update (a Pro feature, the trial included) when a batch of new files arrives. Drag the new audio files onto the panel, or click Add files…: each is matched to a song by sound, not filename, so it does not matter what the delivery was called. A dropped folder is not opened — select the files inside it instead.

A match is ticked for you only when none of its cues needs a second look and the song has no MIDI cues. Click any row to open it in Version compare and review it, and tick it yourself. Apply all applies the ticked rows; anything the sound cannot place asks Which song? and waits. Each song stays individually undoable.